HP VMA-series Memory Arrays Guide de l'utilisateur télécharger pdf (Page 37)

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 37

Gateway Management Network Configuration

You must configure network switches and network connections for the cluster nodes, so that the

master and secondary nodes in a management group can communicate with each other.

Configuring Network Switches

Setting up and defining the network switches for the HP VMA SAN Gateway management group

includes the following tasks:

• Defining Initial IP Addressing on page 35

• Defining Additional Parameters on page 36

• Defining Cluster Name and Node Names on page 36

Before you Begin

Gather the following information for each node in a HP VMA SAN Gateway cluster:

• IP addresses

• Public interface IP address

• Netmask

• Cluster management virtual IP (VIP) address

• HP VMA-series Array IP address

Defining Initial IP Addressing

The following IP address assignments must be performed via serial console or direct connected to

the network switches of the HP VMA SAN Gateway:

• Public Interface Name and IP Address: For each node, define the public interface name, IP

address, and an associated netmask for the system’s private address requirements. (DHCP can

be used for these addresses; however, most installations use static IP addresses.)

• Cluster Management VIP: Define the cluster management virtual IP address. The cluster

management VIP directs all cluster management traffic to the public interface on the master

node.

• HP VMA-series Array IP Address: Define the Memory Array network management IP

address.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 82 83

Pas de commentaire

HP VMA-series Memory Arrays Guide de l'utilisateur Page 37