HP VMA-series Memory Arrays Guide de l'utilisateur télécharger pdf (Page 32)

32 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A

2. Enter the following command.

Output similar to the following appears:

Note: If an installed license shows "no" as the Active output, an error may have been made when

inputting the license key. Double-check the valid license key against the key that is shown in the

show license output.

Verifying Storage Media

This section demonstrates how to verify the devices that are used by the SAN Gateway. For more

information, see the "Command Line Interface Reference" appendix of the

SAN Gateway User’s

Guide

To verify the devices used by the SAN Gateway, do the following:

1. Log in to the master node as admin and enter enable mode.

2. Enter the following command.

All media devices are shown that can be used by the current VMA Memory Gateway (node or

module) as block storage or caching media. A summary line for each device location is shown,

giving the size and status of that device. Media used by the system for other purposes are not

shown.

# show license

License 1: LK2-VSHARE-XXXX-XXXX-XXXX-XXXX-XXXX-XXXX

Feature: VSHARE

Valid: yes

Tied to cluster ID: 99999 (ok)

Active: yes

License 2: LK2-RESTRICTED_CMDS-XXXX-XXXX-XXXX-XXXX-XXXX-XXXX

Feature: RESTRICTED_CMDS

Valid: yes

Tied to cluster ID: 99999 (ok)

Active: yes

{cluster master} > enable

# show media

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 82 83

Pas de commentaire

HP VMA-series Memory Arrays Guide de l'utilisateur Page 32