HP VMA-series Memory Arrays Guide de l'utilisateur télécharger pdf (Page 52)

52 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A

To view existing containers, complete the following steps:

1. Log in as an administrator to the VMA Gateway attached to Port 1 of the HP VMA-series

Array.

2. Use the configure terminal command to enter Configure mode.

3. Enter the media block id all enable command to enable all block containers.

The

block parameter ensures that you enable vSHARE devices. The all parameter ensures

that every block container is enabled.

4. To view all the containers were created, enter the show containers command. Information

about the containers displays.

Configuring Target Ports

The second step in configuring a HP VMA SAN Gateway is to configure the target ports. The target

ports control access to a particular LUN, which may be useful for both security and bandwidth

management.

This section covers the following topics:

• Supported Target Ports on page 49

• Configuring Fibre Channel Target Ports on page 50

Supported Target Ports

In a vSHARE system, the HP VMA-series Arrays are the targets and the host system (for example,

one or more database servers or application servers) are the

initiators. The storage systems have

storage target devices (LUNs) that the hosts access through the HP VMA SAN Gateway.

The VMA SAN Gateway supports Fibre Channel target ports.

# configure terminal

(config) #

(config) # media <tab>

(config) # media block id all enable

> enable

# show containers

Container LUNs Total Free Ports HostnameA HostnameB

Status

----------------------------------------------------------------------

C-2 150 199G 50176M A,B <hostname> <hostname> cluster

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 82 83

Pas de commentaire

HP VMA-series Memory Arrays Guide de l'utilisateur Page 52