HP VMA-series Memory Arrays Guide de l'utilisateur télécharger pdf (Page 57)

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 57

1. From the CLI, enter into Enable mode using the enable command and then Configure mode using the

configure terminal command.

2. All LUNs are created and managed within a container. To view the available containers, use

the show containers command.

Check the size of the containers. LUNs are implemented in 1 GB increments; the size of the

container may restrict the number of LUNs that may be created.

3. Enter the lun create command to create LUNs within a container.

The command creates 20 LUNs of equal size in the container. Use the

nozero option to ensure that

the data is not zeroed-out, which could take considerable time depending on the size of the

container.

Typically, fewer than 40 LUNs would be created within a container; however, the creation of up to

1024 LUNs is supported per container.

lun create Command

The

lun create command enables you to create a LUN within a specified storage container

connected to the VMA SAN Gateway.

Syntax

[no] lun create container <container_name> name <LUN_name> size [<size GB>

| equal] [quantity <number>] [nozero] [readonly] [startnum <unsigned

integer>] [blksize 512 | 4096] [offline]

Syntax Description

The following table shows syntax for LUN commands.

> enable

# configure terminal

(config) #

> enable

# configure terminal

(config) # show containers

(config) # lun create container <container_name> name <LUN_name> size

equal quantity 20 nozero

name

Defines the name of LUN to be created; used as a prefix if the

quantity of LUNs created is greater than one.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 82 83

Pas de commentaire

HP VMA-series Memory Arrays Guide de l'utilisateur Page 57