HP OfficeConnect Firewall Series Manuel d'utilisateur télécharger pdf (Page 100)

Chapter 14 Configuring IPSec VPN OfficeConnect Gigabit VPN Firewall User’s Manual

packets according to the user-configured rule. The parameters that should be

configured are:

 the network addresses of internal and remote networks.

 the remote gateway address and the local gateway address.

 pre-shared secret for remote gateway authentication.

 appropriate priority for the connection.

This option sequence brings up the screen as illustrated in Figure 4.2. Fields and

buttons represent the basic VPN parameters. Use them to configure basic

Access Rule that will be used to establish a tunnel from local secure group to

remote secure group with basic parameters.

Options in this screen allow you to:

 Add a VPN policy, and set basic parameters for it

 Modify a VPN policy

 Delete an existing VPN policy

14.2.1 Add a Rule for VPN Connection Using Pre-shared Key

VPN Tunnel Configuration Page, as illustrated in the Figure 14.2, is used to

configure a rule for VPN connection using pre-shared key

To add a rule for a VPN connection, follow the instructions below:

1. Log into Configuration Manager as admin, click the VPN menu, and

then click the IPSec submenu. The VPN policy list table displays, as

shown in Figure 14.1. IPSec VPN Policy List Table.

2. Prior to adding a VPN policy, make sure that the VPN service is

enabled in VPN policy list table.

3. Click on the button to enter the VPN Tunnel

Configuration Page as illustrated in Figure 14.2.

4. Enter a desired name, preferably a meaningful name that signifies

the nature of the VPN connection, in the ―Name‖ field. Note that only

alphanumeric characters are allowed in a name.

5. Click on ―Enable‖ or ―Disable‖ radio button to enable or disable this

rule.

Figure 14.1. IPSec VPN Policy List Table

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 155 156

Pas de commentaire

HP OfficeConnect Firewall Series Manuel d'utilisateur Page 100