HP OfficeConnect Firewall Series Manuel d'utilisateur télécharger pdf (Page 95)

OfficeConnect VPN Firewall User’s Manual Chapter 14. Configuring IPSec VPN

6. If you want to assign another WAN port as a backup interface,

please tick on the checkbox in the Backup Interfaces field.

7. Enter a number between 1 and 86400, in the Deferred Time field.

Please note that the default value is 600 seconds.

8. Click on the button to save the settings.

13.3 Configuring WAN Load-Balancing

The configuration parameters for the WAN Load-Balancing are shown in the

following table.

Field

Description

Connectivity Check

This option is available under both ―Load balancing‖

and ―Rollover‖ mode and mandatory for ―Rollover‖.

Connectivity check is used to monitor the link status

for the WAN ports by sending PING request packets

periodically to the configured IP address.

Enable Connectivity

Check

To enable the connectivity check, please tick this

check box.

Check Interval

The interval that the router sends PING request

packets at. The allowable value is 1 to 60 seconds.

Check IP Address

Enter the IP address of the specific network device

that the traffic will pass through. This field is optional.

Normally, you don't need to provide any IP address

here, unless you know the traffic must pass a specific

network device. If this field is absent, the route will

send PING request to gateway IP address to monitor

Field

Description

the link status.

Gateway IP

Address

The gateway IP address. Please note that this field is

read-only.

Link Status

Display the current WAN link status.

Load Balancing

Settings

When the WAN Load Balancing is selected. The

OfficeConnect Gigabit VPN Firewall can distribute

outgoing traffic across all active WAN interfaces on a

per-connection basis.

Algorithm

Select one of the following algorithms from the drop-

down list:

(a) Weighted Round Robin: This algorithm

assigns network session capacity to each

WAN link in different portions, called weight,

and handles network traffic in order without

priority.

(b) Least Traffic First: By the implication of its

name, the algorithm chooses the

dispatched WAN link according to the most

bandwidth remains.

Bandwidth

Allocation (in Ratio)

You can configure this algorithm to obtain the weight

factors from normalizing the configured WAN TX

bandwidths (tick the box ―Calculate from [Tx Max.]‖) or

just set these values manually.

Follow these steps to configure the WAN Load-Balancing:

1. Click on Traffic MGMT > WAN Link Mgmt to enter the WAN Link

Configuration page. See Figure 13.1 WAN Link Mgmt Configuration

Page.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 155 156

Commentaires sur ces manuels

Pas de commentaire

HP OfficeConnect Firewall Series Manuel d'utilisateur Page 95

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel HP OfficeConnect Firewall Series