HP OfficeConnect Firewall Series Manuel d'utilisateur Page 91

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 156
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 90
OfficeConnect VPN Firewall User’s Manual Chapter 14. Configuring IPSec VPN
77
3. Click button to create a new QoS Class Object. See
Figure 12.5 Add a new QoS Class Object
4. Enter a name to the new QoS Class Object.
5. If you want to enable traffic shaping and prioritization, make ―Enable
Traffic Shapping / Prioritize check box checked.
6. Click on Enable Traffic Shaping radio button in case you want to
configure a QoS policy with traffic shaping mechanism. And then
provide minimum/maximum bandwidth for the outgoing (TX) direction
and incoming (RX) direction.
7. Click on Enable Prioritize radio button in case you want to configure
a QoS policy with traffic prioritize mechanism. After that, user can
select DiffServ Code Point (DSCP) or 802.1p tag for the ingress
packet.
8. To configure traffic prioritization for the egress packet, make the
Enable Remark check box checked and then select DiffServ Code
Point and 802.1p tag.
9. Click on the button to save the settings.
12.4 Traffic Classification
OfficeConnect Gigabit VPN Firewall allows you to define QoS policy to classify
the traffic based on the following parameters:
Source / destination IP address
Source / destination port
Protocol
DiffServ Code Point (DSCP)
OfficeConnect Gigabit VPN Firewall supports two priority marking methods for
packet prioritization:
DSCP
802.1p Priority
The matching of packets by rules is connection-based, known as Stateful Packet
Inspection (SPI), using the same connection-tracking mechanism used by
OfficeConnect Gigabit VPN Firewall. Once a packet matches a rule, all
subsequence packets with the same attributes receive the same QoS
parameters, both inbound and outbound.
To configure the QoS policy, follow these steps:
1. Click Traffic MGMT from the main menu and then click QoS sub-
menu to enter the QoS Configuration page.
2. Select an appropriate interface from Policy on drop-down list.
3. Click button to enter the QoS Policy Configuration
page. See Figure 12.6.
Vue de la page 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 155 156

Commentaires sur ces manuels

Pas de commentaire