HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 245)

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

interface loopback <label>

Use the interface loopback command to create a virtual interface that can be assigned layer 3 and higher

properties and is always up unless the router is shut down. Use the no form of this command to delete a

configured loopback interface.

Syntax Description

<label> Specifies the numerical virtual loopback interface identifying label (valid range:

Default Values

By default, there are no configured loopback interfaces.

Command Modes

(config)# Global Configuration Mode required

Usage Examples

The following example creates a loopback virtual interface (labeled 1) and enters the Loopback Interface

Configuration Mode:

(config)#interface loopback 1

(config-loop 1)#

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 245