HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 410)

SROS Command Line Interface Reference Guide Crypto Map Manual Command Set

set peer <address>

Use the set peer command to set the IP address of the peer device.

Syntax Description

<address> Enter the IP address of the peer device.

Default Values

There are no default settings for this command.

Command Modes

(config-crypto-map)# Crypto Map Configuration Mode (IKE or Manual)

Functional Notes

If no peer IP address is configured, the manual crypto map is not valid and not complete. A peer IP

address is required for manual crypto maps. To change the peer IP address, the no set peer command

must be issued first; then the new peer IP address can be configured.

Usage Examples

The following example sets the peer IP address of 10.100.23.64:

(config-crypto-map)#set peer 10.100.23.64

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 410