HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 512)

100

101

SROS Command Line Interface Reference Guide T1 Interface Configuration Command Set

loopback remote line [fdl | inband]

Use the loopback remote line command to send a loopback code to the remote unit to initiate a line

loopback. Use the no form of this command to send a loopdown code to the remote unit to deactivate the

loopback.

Syntax Description

fdl Uses the facility data link (FDL) to initiate a full 1.544 Mbps loopback of the signal

received by the remote unit from the network.

inband Uses the inband channel to initiate a full 1.544 Mbps physical loopback (metallic

loopback) of the signal received from the network.

Default Values

No defaults necessary for this command.

Command Modes

(config-t1 1/1)# T1 Interface Configuration Mode required (does not apply to DSX-1 interfaces)

Functional Notes

The following diagram depicts the difference between a line and payload loopback.

Usage Examples

The following example initiates a remote line loopback using the FDL:

(config)#interface t1 1/1

(config-t1 1/1)#loopback remote line fdl

T1 Network Interface

DS1

NI CSU

Payload Loopback

Line Loopback

1 2 ... 507 508 509 510 511 512 513 514 515 516 517 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 512

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series