HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 552)

100

101

SROS Command Line Interface Reference Guide Modem Interface Configuration Command Set

MODEM INTERFACE CONFIGURATION COMMAND SET

To activate the Modem Interface Configuration , enter the interface modem command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface modem 1/2

Router(config-modem 1/2)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

caller-id override [always <number> | if-no-cid <number>] on page 553

dialin on page 554

modem countrycode <countryname> on page 555

Note

The modem interface number in the example above is shown as modem 1/2. This number is

based on the interface’s location (slot/port) and could vary depending on the unit’s

configuration. Use the do show interfaces command to determine the appropriate interface

number.

1 2 ... 547 548 549 550 551 552 553 554 555 556 557 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 552

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series