HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 305)

100

101

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

ip sntp source-interface <interface>

The ip sntp source-interface command to use the specified interface’s IP address as the source IP address

for SNTP traffic transmitted by the unit. Use the no form of this command if you do not wish to override

the normal source IP address.

Syntax Description

<interface> Enter the interface to be used as the source IP address for SNTP traffic.

Type ip sntp source-interface? for a complete list of valid interfaces.

Default Values

No default value is necessary for this command.

Command Modes

(config)# Global Configuration Mode required

Functional Notes

This command allows you to override the sender field in the IP packet. If you have multiple interfaces in

your unit, changing the sender tells the receiver where to send replies. This functionality can also be used

to allow packets to get through firewalls that would normally block the flow.

Usage Examples

The following example configures the unit to use the loopback 1 interface as the source IP for SNTP

traffic:

(config)#ip sntp source-interface loopback

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 305

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series