HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 909)

Router (OSPF) Configuration Command Set

default-metric <value>

Use the default-metric command to set a metric value for redistributed routes.

Syntax Description

<value> Set the default metric value (range: 0-4294967295).

Default Values

By default, this value is set at 20.

Command Modes

(config-ospf)# Router (OSPF or RIP) Configuration Mode required

Functional Notes

The metric value defined using the redistribute command overrides the default-metric command’s metric

setting. See

redistribute ospf [metric <value>] on page 900 for related information.

Usage Examples

The following example shows a router using both RIP and OSPF routing protocols. The example

advertises RIP-derived routes using the OSPF protocol and assigns the RIP-derived routes an OSPF

metric of 10.

(config)#router ospf

(config-ospf)#default-metric 10

(config-ospf)#redistribute rip

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 909