HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 585)

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)

traps on the interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), Ethernet sub-interfaces (eth 0/1.1),

VLAN, DDS (dds 1/1), serial (ser 1/1), virtual Frame Relay (fr 1), and SHDSL

(shdsl 1/1) interfaces.

Usage Examples

The following example enables SNMP on the virtual Frame Relay interface:

(config)#interface frame-relay 1

(config-fr 1)#snmp trap

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 585