HP 7000 dl Router Series Guide de l'utilisateur Page 689

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 941
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 688
SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 689
ip unnumbered <interface>
Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP
processing on the active interface. Use the no form of this command to remove the unnumbered
configuration.
Syntax Description
<interface> Specifies the interface (in the format type slot/port) that contains the IP address
to use as the source address for all packets transmitted on this interface.
Valid interfaces include: ATM sub-interface, Ethernet, virtual Frame Relay
sub-interfaces, virtual PPP, loopback interfaces, and VLAN interfaces.
Default Values
By default, all interfaces are configured to use a specified IP address (using the ip address command).
Command Modes
(config-interface)# Interface Configuration Mode required
Valid interfaces include: ATM sub-interface, Ethernet, virtual Frame Relay
sub-interfaces, and virtual PPP interfaces.
Functional Notes
If ip unnumbered is enabled on an interface, all IP traffic from the interface will use a source IP address
taken from the specified interface. For example, specifying ip unnumbered eth 0/1 while in the Frame
Relay Sub-Interface Configuration Mode configures the Frame Relay sub-interface to use the IP address
assigned to the Ethernet interface for all IP processing. In addition, the Secure Router OS uses the
specified interface information when sending route updates over the unnumbered interface.
Usage Examples
The following example configures the ATM sub-interface 1.1 to use the IP address assigned to the
Ethernet interface (eth 0/1):
(config)#interface atm 1.1
(config-atm 1.1)#ip unnumbered eth 0/1
Vue de la page 688
1 2 ... 684 685 686 687 688 689 690 691 692 693 694 ... 940 941

Commentaires sur ces manuels

Pas de commentaire