HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 669)

100

101

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set

ip access-group <listname> [in | out]

Use the ip access-group command to create an access list to be used for packets transmitted on or received

from the specified interface. Use the no form of this command to disable this type of control.

Syntax Description

listname Assigned IP access list name.

in Enables access control on packets received on the specified interface.

out Enables access control on packets transmitted on the specified interface.

Default Values

By default, these commands are disabled.

Command Modes

(config-interface)# Interface Configuration Mode required.

Functional Notes

When this command is enabled, the IP destination address of each packet must be validated before being

passed through. If the packet is not acceptable per these settings, it is dropped.

Usage Examples

The following example sets up the router to only allow Telnet traffic into the ATM sub-interface:

(config)#ip access-list extended TelnetOnly

(config-ext-nacl)#permit tcp any any eq telnet

(config-ext-nacl)#int atm 1.1

(config-atm 1.1)#ip access-group TelnetOnly in

1 2 ... 664 665 666 667 668 669 670 671 672 673 674 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 669

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series