HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 454)

100

101

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set

ip address <address> <mask> secondary

Use the ip address command to define an IP address on the specified interface (only one primary address

is allowed). Use the optional secondary keyword to define a secondary IP address. Use the no form of

this command to remove a configured IP address.

Syntax Description

<address> Defines the IP address for the interface in dotted decimal notation (for example:

192.22.73.101).

<mask> Specifies the subnet mask that corresponds to the listed IP address.

secondary Optional keyword used to configure secondary IP addresses for the specified

interface. Multiple secondary IP addresses may be assigned (no limit).

Default Values

By default, there are no assigned IP addresses.

Command Modes

(config-interface)# Interface Configuration Mode required (applies to all physical interfaces as well as

virtual interfaces)

Functional Notes

Use secondary IP addresses to allow dual subnets on a single interface (when you need more IP

addresses than the primary subnet can provide). When using secondary IP addresses, avoid routing loops

by verifying that all devices on the network segment are configured with secondary IP addresses on the

secondary subnet.

Usage Examples

The following example configures a secondary IP address of 192.22.72.101/30:

(config)#interface ethernet 0/1

(config-eth 0/1)#ip address 192.22.72.101 255.255.255.252 secondary

1 2 ... 449 450 451 452 453 454 455 456 457 458 459 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 454

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series