HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 490)

SROS Command Line Interface Reference Guide DDS Interface Configuration Command Set

loopback [dte | line | remote]

Use the loopback command to initiate a specified loopback on the interface. Use the no form of this

command to deactivate the loop.

Syntax Description

dte Initiates a loop to connect the transmit and receive path through the unit.

line Initiates a loop of the DDS circuit towards the network by connecting the transmit

path to the receive path.

remote Transmits a DDS loop code over the circuit to the remote unit. In response, the

remote unit should initiate a line loopback.

Default Values

No default values necessary for this command.

Command Modes

(config-dds 1/1)# 56K/64K (DDS) Interface Configuration Mode required

Usage Examples

The following example activates a line loopback on the DDS interface:

(config)#interface dds 1/1

(config-dds 1/1)#loopback line

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 490