HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 903)

100

101

Router (OSPF) Configuration Command Set

ROUTER (OSPF) CONFIGURATION COMMAND SET

To activate the Router (OSPF) Configuration, enter the router ospf command at the Global Configuration

Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

router ospf

Router(config-ospf)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

do on page 928

end on page 929

exit on page 930

All other commands for this command set are described in this section in alphabetical order.

area <area id> default-cost <value> on page 904

area <area id> range <ip address> <network mask> [advertise | not-advertise] on page 905

area <area id> stub [no-summary] on page 906

auto-cost reference-bandwidth <rate> on page 907

default-information-originate [always] [metric value] [metric-type type] on page 908

default-metric <value> on page 909

network <ip address> <wildcard> area <area id> on page 910

redistribute connected on page 911

redistribute rip on page 912

redistribute static on page 913

summary-address <address> <mask | prefix mask> not-advertise on page 914

timers lsa-group-pacing <seconds> on page 915

timers spf <delay> <hold> on page 916

1 2 ... 898 899 900 901 902 903 904 905 906 907 908 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 903

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series