HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 654)

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set

backup backup-delay <seconds>

Use the backup backup-delay command to configure the amount of time the router will wait after the

failure condition is recognized before attempting to backup the link. Use the no form of this command to

return to the default value.

Syntax Description

<seconds> Specifies the delay period (in seconds) a failure must be active before the

will enter backup operation on the interface (valid range: 10 to 86400

Default Values

<seconds> 10 seconds

Command Modes

(config-fr 1.16)# Virtual Frame Relay Sub-Interface Configuration Mode

(config-atm 1.1)# ATM Sub-Interface Configuration Mode

Usage Examples

The following configures the Secure Router OS to wait 60 seconds (on an endpoint with an active alarm

condition) before attempting backup operation:

(config)#interface atm 1.1

(config-atm 1.1)#backup backup-delay 60

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 654