HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 840)

100

101

SROS Command Line Interface Reference Guide HDLC Command Set

ip unnumbered <interface>

Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP

processing on the active interface. Use the no form of this command to remove the unnumbered

configuration.

Syntax Description

<interface> Specifies the interface (in the format type slot/port) that contains the IP address

to use as the source address for all packets transmitted on this interface.

Default Values

By default, all interfaces are configured to use a specified IP address (using the ip address command).

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

If ip unnumbered is enabled on an interface, all IP traffic from the interface will use a source IP address

taken from the specified interface. For example, specifying ip unnumbered eth 0/1 while in the Frame

Relay Sub-Interface Configuration mode configures the Frame Relay sub-interface to use the IP address

assigned to the Ethernet interface for all IP processing. In addition, the SROS uses the specified interface

information when sending route updates over the unnumbered interface.

Usage Examples

The following example configures the HDLC interface to use the IP address assigned to the Ethernet

interface (eth 0/1):

(config)#interface hdlc 1

(config-hdlc 1)#ip unnumbered eth 0/1

1 2 ... 835 836 837 838 839 840 841 842 843 844 845 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 840

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series