HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 538)

SROS Command Line Interface Reference Guide E1 Interface Configuration Command Set

remote-loopback

Use the remote-loopback command to configure the interface to accept loopback requests from a remote

unit (or the service provider). Use the no form of this command to disable this feature.

Syntax Description

No subcommands.

Default Values

No default value is necessary for this command.

Command Modes

(config-interface)# Interface configuration mode.

Functional Notes

This controls the acceptance of any remote loopback requests. When enabled, remote loopbacks are

detected and cause a loopback to be applied. When disabled, remote loopbacks are ignored.

Usage Examples

The following example enables remote loopbacks on the E1 interface:

(config)#interface e1 1/1

(config-e1 1/1)#remote-loopback

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 538