HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 887)

Line (Telnet) Interface Config Command Set

LINE (TELNET) INTERFACE CONFIG COMMAND SET

To activate the Line (Telnet) Interface Configuration , enter the line telnet command specifying a Telnet

session(s) at the Global Configuration Mode prompt. For example:

configure terminal

Router(config)#

line telnet 0 4

Router(config-telnet0-4)#

You can select a single line by entering the line telnet command followed by the line number (0-4). For

configure terminal

Router(config)#

line telnet 2

Router(config-telnet2)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

do on page 928

end on page 929

exit on page 930

All other commands for this command set are described in this section in alphabetical order.

access-class <listname> in on page 888

line-timeout <minutes> on page 889

password [md5] <password> on page 893

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 887