HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 525)

100

101

SROS Command Line Interface Reference Guide DSX-1 Interface Configuration Command Set

loopback remote line inband

Use the loopback remote line inband command to send a loopback code to the remote unit to initiate a

line loopback. Use the no form of this command to send a loopdown code to the remote unit to deactivate

the loopback.

Syntax Description

inband Uses the inband channel to initiate a full 1.544 Mbps physical loopback (metallic

loopback) of the signal received from the network.

Default Values

No defaults necessary for this command.

Command Modes

(config-t1 1/1)# T1 or DSX-1 Interface Configuration Mode required.

(config-t1 1/2)#

Functional Notes

A remote loopback can only be issued if a bind does not exist on the interface and if the signaling mode is

set to none. The following diagram depicts the difference between a line and payload loopback.

Usage Examples

The following example initiates a remote line loopback using the inband channel:

(config)#interface t1 1/2

(config-t1 1/2)#loopback remote line inband

T1 Network Interface

DS1

NI CSU

Payload Loopback

Line Loopback

1 2 ... 520 521 522 523 524 525 526 527 528 529 530 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 525

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series