HP 7000 dl Router Series Guide de l'utilisateur Page 636

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 941
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 635
SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 636
ip unnumbered <interface>
Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP
processing on the active interface. Use the no form of this command to remove the unnumbered
configuration.
Syntax Description
<interface> Specifies the interface (in the format type slot/port) that contains the IP address
to use as the source address for all packets transmitted on this interface.
Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay sub-interfaces (fr
1.16), virtual PPP (ppp 1), loopback interfaces, and VLAN interfaces.
Default Values
By default, all interfaces are configured to use a specified IP address (using the ip address command).
Command Modes
(config-interface)# Interface Configuration Mode required
Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay sub-interfaces (fr
1.16), and virtual PPP interfaces (ppp 1).
Functional Notes
If ip unnumbered is enabled on an interface, all IP traffic from the interface will use a source IP address
taken from the specified interface. For example, specifying ip unnumbered eth 0/1 while in the Frame
Relay Sub-Interface Configuration Mode configures the Frame Relay sub-interface to use the IP address
assigned to the Ethernet interface for all IP processing. In addition, the Secure Router OS uses the
specified interface information when sending route updates over the unnumbered interface.
Usage Examples
The following example configures the Frame Relay interface (labeled frame-relay 1.16) to use the IP
address assigned to the Ethernet interface (eth 0/1):
(config)#interface frame-relay 1.16
(config-fr 1.16)#ip unnumbered eth 0/1
Vue de la page 635
1 2 ... 631 632 633 634 635 636 637 638 639 640 641 ... 940 941

Commentaires sur ces manuels

Pas de commentaire