HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 546)

SROS Command Line Interface Reference Guide G.703 Interface Configuration Command set

coding [ami | hdb3]

Use the coding command to configure the line coding for the E1 or G.703 physical interface. This setting

must match the line coding supplied on the circuit by the PBX.

Syntax Description

ami Configures the line coding for alternate mark inversion.

hdb3 Configures the line coding for high-density bipolar 3.

Default Values

By default, all E1 interfaces are configured with HDB3 line coding.

Command Modes

(config-e1 1/1)# E1 or G.703 Interface Configuration Mode required.

(config-e1 1/2)#

Functional Notes

The line coding configured in the unit must match the line coding of the E1 circuit. A mismatch will result in

line errors (e.g., BPVs).

Usage Examples

The following example configures the G.703 interface for AMI line coding:

(config)#interface e1 1/2

(config-e1 1/2)#coding ami

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 546