HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 713)

100

101

SROS Command Line Interface Reference Guide BGP Neighbor Configuration Command Set

e/jointfilesconvert/63229/bgp-multihop <hop count>

Use the e/jointfilesconvert/63229/bgp-multihop command to configure the maximum hop count of BGP messages to a neighbor.

Use the no form of this command to return to the default setting.

Syntax Description

<hop count> Specifies the maximum hop count of BGP messages to a neighbor. Range: 1 to

254.

Default Values

By default, e/jointfilesconvert/63229/bgp-multihop is set to 1.

Command Modes

(config-/jointfilesconvert/63229/bgp-neighbor)# BGP Neighbor Configuration Mode

Functional Notes

This command allows an eBGP neighbor to be on a network that is not directly connected. Normally, eBGP

peers are directly connected. In certain applications, a non-BGP device such as a firewall or router may

reside between eBGP peers. In this case, the eBGP-multihop command is required to allow updates to

have a TTL>1 and to allow received BGP updates to be added to the BGP table when the next-hop

address is not directly connected.

Usage Examples

The following exampleallows a BGP message to travel 10 hops to a neighbor:

(config-/jointfilesconvert/63229/bgp-neighbor)#e/jointfilesconvert/63229/bgp-multihop 10

1 2 ... 708 709 710 711 712 713 714 715 716 717 718 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 713

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series