HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 906)

100

101

Router (OSPF) Configuration Command Set

area <area id> stub [no-summary]

Use this command to configure an area as a stub area. Use the no form of this command to disable

stub-designation for areas defined as stubs using this command.

Syntax Description

<area id> Identifier for this stub area. Enter as an integer (range: 0-4294967295) or an IP

address <A.B.C.D>.

no-summary Optional.

Use this optional keyword to designate the area as a total stub area. No

summary link advertisements will be sent by the ABR into the stub area.

Default Values

By default, OSPF is not enabled.

Command Modes

(config-ospf)# Router (OSPF) Configuration Mode required

Technology Review

It is important to coordinate configuration of all routers and access servers in the stub area. The area stub

command must be configured for each of those pieces of equipment. Use the area router configuration

command with the area default-cost command to specify the cost of a default internal router sent into a

stub area by an ABR. See

area <area id> default-cost <value> on page 904 for related information.

Usage Examples

(config)#router ospf

(config-ospf)#area 2 stub

1 2 ... 901 902 903 904 905 906 907 908 909 910 911 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 906

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series