HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 897)

100

101

Router (RIP) Configuration Command Set

network <address> <subnet mask>

Use the network command to enable RIP on the specified network. The Secure Router OS will only allow

processing (sending and receiving) RIP messages on interfaces with IP addresses that are contained in the

networks listed using this command. All RIP messages received on interfaces not listed using this

command will be discarded. To allow for receiving and participating in RIP but not for transmitting, use

the passive-interface command (see passive-interface <interface> on page 898). Use the no form of this

command to remove a network from the list.

Syntax Description

<address> IP address of the network on which RIP will be enabled

<subnet mask> Subnet mask that corresponds to the entered IP address

Default Values

By default, RIP is not enabled.

Command Modes

(config-rip)# Router (RIP) Configuration Mode required

Usage Examples

The following example enables RIP on the 102.22.72.252/30, 192.45.2.0/24, and 10.200.0.0/16 networks:

(config)#router rip

(config-rip)#network 102.22.72.252 255.255.255.252

(config-rip)#network 192.45.2.0 255.255.255.0

(config-rip)#network 10.200.0.0 255.255.0.0

1 2 ... 892 893 894 895 896 897 898 899 900 901 902 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 897

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series