HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 786)

Command Reference Guide Tunnel Configuration Command Set

ip address <address> <mask> secondary

Use the ip address command to define an IP address on the specified interface. Use the no form of this

command to remove a configured IP address.

Syntax Description

<address> Defines the IP address for the interface in dotted decimal notation (for example:

192.22.73.101).

<mask> Specifies the subnet mask that corresponds to the listed IP address.

Optional. Keyword used to configure a secondary IP address for the specified

Default Values

By default, there are no assigned IP addresses.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC

virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Usage Examples

The following example configures an IP address of 192.22.72.101/30:

(config)#interface tunnel 1

(config-tunnel 1)#ip address 192.22.72.101 255.255.255.252

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 786