HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 808)

100

101

Command Reference Guide Tunnel Configuration Command Set

tunnel sequence-datagrams

Use the tunnel sequence-datagrams command to enable sequence number checking on incoming Generic

Routing Encapsulation (GRE) packets, to drop packets arriving out of order, and to include a sequence

number in outgoing packets. Use the no form of this command to disable sequence number checking.

Syntax Description

No subcommands.

Default Values

By default, this command is disabled.

Command Modes

(config-tunnel x)# Tunnel Interface Configuration Mode

Functional Notes

Both ends of the tunnel must have sequence numbering enabled. When both endpoints have sequence

numbering enabled, a packet arriving with a sequence number less than the current expected value will be

dropped. If the endpoints differ in their sequence numbering configuration, all packets will still flow without

any sequence number verification. Be careful enabling sequence number verification on a tunnel. The

tunnel can easily become out of sequence due to network conditions outside of the tunnel endpoints. It

may be difficult to establish a successful traffic flow after an out of sequence condition occurs.

Technology Review

When enabled, the next valid sequence number will be placed in the GRE header of each outgoing packet,

and the sequence number present bit will be set.

Usage Examples

The following example enables sequence number processing on the tunnel interface:

(config)#interface tunnel 1

(config-tunnel 1)#tunnel sequence-datagrams

1 2 ... 803 804 805 806 807 808 809 810 811 812 813 ... 940 941

Commentaires sur ces manuels

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 808

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau HP 7000 dl Router Series