HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 579)

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set

frame-relay lmi-t392dce <seconds>

Use the frame-relay lmi-t392dce command to set the T392 polling verification timer for the DCE

endpoint. Typical applications should leave the default value for this timer. Use the no form of this

command to return to the default value.

Syntax Description

<seconds> Sets the timer value in seconds (valid range: 5-30)

Default Values

<seconds> 10 seconds

Command Modes

(config-fr 1)# Virtual Frame Relay Interface Configuration Mode required

Functional Notes

The T392 sets the timeout (in seconds) between polling intervals. This parameter needs to be a few

seconds longer than the T391 setting of the attached Frame Relay device.

Usage Examples

The following example sets the T392 timer for 15 seconds:

(config)#interface frame-relay 1

(config-fr 1)#frame-relay lmi-t392dce 15

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 579